Operation Manual

Function

Trigger

For configuring 12 V output to an external screen equipped with a trigger function.

Setting Description

Off No output.

On (Power) Outputs control signals (12 V) from the trigger terminal when the power is turned

on.

After the power is turned off, output stops when the unit shifts to the Standby

mode after cooling is complete.

You

can

also output signals in the Standby mode by pressing the [OK] button.

On (Anamo) Outputs control signals when the “Anamorphic” setting is switched from “Off” to “A”

or “B”.

Off Timer

For setting the timing to power off the unit automatically (“1 Hour”, “2 Hours”, “3 Hours”, or “4 Hours”) when it is not

operated for a period of time.

High Altitude Mode

Set to “On” when using the projector at a location of low atmospheric pressure (higher than 900 m above sea level).

ECO Mode

Setting Description

On Minimizes power consumption in the Standby mode.

If there

is no signal transmission or operation for 30 minutes while an image is

projected, the power is turned off automatically.

Off Set to “Off” if RS-232C / LAN communication is performed or the HDMI link function

is used in the Standby mode.

Communication Terminal

For setting the external control terminal to be used to “RS-232C” or “LAN”.

Network

Setting Description

DHCP Client On Obtains the IP address automatically from the DHCP server inside the connected

network.

Off For configuring the network settings manually.

IP Address For configuring the IP address.

Subnet Mask For configuring the subnet mask.

Default Gateway For configuring the default gateway.

MAC Address Displays the MAC address of the unit.

Set Applies the network settings.

Adjust/Set