OperationManual

- 40 -
ENGLISH
Attaching an arm stand
The tilt stand is interchangeable with commercially available arms.
After checking the specications of the arm to be used, pay attention to the following
points when selecting.
• Come with a mount plate with 4 slotted screw holes at
100 mm × 100 mm, and
• Bear the total weight of the LCD panel (without the stand) and
the cables connected to it. For more information, ask the arm
maker.
Note
Use the original screws to use the LCD panel back on its
original tilt stand.
Select the screw size carefully according to the plate thickness. If the screws are
too long, they could damage the internal parts. If they are too short, the
connection becomes loose and the monitor could fall o.
Mounting plate thickness Screw size
3.5–4.5 mm ISO M4 × 12
1.5–3.5 mm ISO M4 × 10 (Originally used)
Below 1.5 mm ISO M4 × 8
Note: We are not liable for any damage or injury resulting from replacing stands.
Warning
How to attach an arm stand
1
Place a soft cloth or cushioning material over a stable even surface to prevent
scratches on the screen.
2
Place the monitor on the soft cloth with the screen face down.
3
Remove the stand. (Use a Phillips head screwdriver to remove the four screws
indicated by the arrows in
the gure.)
4
Attach the monitor unit to
the arm. (Perform in the
reverse order of removing
the arm.)
Note
When attaching the
monitor to an arm
that has already been
xed, be sure to carry
out the work with two
or more people to ensure safety. If the monitor falls or topples, it can result
in injury or monitor malfunction.
115 mm
100 mm
115 mm
100 mm
Cushioning
material