OperationManual
- 39 -
ENGLISH
Reference
Power save mode
The monitor enters into power save mode after idling for a certain period of time to
reduce power consumption.
Refer to the workstation instruction manual on how to set it.
Digital input
This monitor supports digital signal. It is normal for noise to occur during startup,
shutdown, and/or at switching resolutions. This is caused by the graphics card in the
system as it switches resolution. Also, when switching resolutions, a 5 sq. mm white
area may appear under the front sensor. In both cases, they are not failures.
Note
Turn o the system before connecting and disconnecting the signal cables.
It could damage the graphics card.
Operating principle
Image signals from acquisition devices or picture-archiving communication system
(workstation) shall be transmitted to the monitor via DVI or DisplayPort terminals.
By transmitting image signals of the system to the input unit of the monitor, the
monitor can provide images on its screen (LCD panel) via its signal processing circuit. It
is possible for users to congure the monitor freely for suitable observation by OSD
because of the input unit and the signal processing circuit which correspond to various
input signals.
Input unit
Signal
processing
circuit
Power unit
Operation unit
LCD Module