OperationManual

- 38 -
ENGLISH
How to set Power save, Human Sensor, and DP Power
Power save mode varies based on a combination of settings of Human Sensor &
DP Power in Management-2 in OSD menu and “Power & sleeps settings” of your
workstation.
Please customize each of those settings according to your environment.
Power Save Mode
Power & Sleep
setting
Human
Sensor
DP Power
LED indicator
Normal Green OFF OFF ON
low Orange OFF ON ON
mid Orange ON
―
ON
high Orange ON
―
OFF
low: Power save mode by Human sensor. Power save mode is activated when your
set time is over, if there is no user in front of your monitor (Human Sensor).
Screen automatically turns back from power save mode when a user is back
there.
mid: Power save mode by “Power & sleep settings” of your workstation.
Power save mode is activated by no image signal from your workstation, and
screen automatically turns back after inputting image signal.
high: Power save mode by your combination of “Power & sleep settings” of your
workstation and DP Power of this monitor.
Power save mode is activated by no image signal from your workstation and
DP Power o, and this mode minimizes power consumption. The screen
automatically turns back after inputting image signal and turning on the
stand-by key.
Conguration Setting
CL-R813 has the following ve Conguration settings saved as factory defaults
before shipping
.
Conguration
Luminance (cd/m
2
)
Color Gamma
Max. Min.
Cong1 280 0.5 7500 K DICOM GSDF
Cong2 280 1 7500 K DICOM GSDF
Cong3 280 0.5 7500 K EXP. 2.2
How to set Input Source during power save
In the case that power save mode is activated while input source is mismatched to a
connector of your workstation.
e.g.) Your workstation: “DisplayPort IN2” and Input Source: “Display Port 1”.
・
Tap
any Operation key.
・
LED indicator tuns from orange to green after a while, and then “No Signal” is
shown after fteen seconds from turning in green
・
Tap
any Operation key while “No Signal” is shown, and “Operation Key Guide
(Input Source)” appears and set it.