OperationManual

- 37 -
ENGLISH
Human Sensor setting
Human sensor is always monitoring whether a user is in front of this monitor.
Power save (low) function is activated when its sensor cannot detected any user within
your set time.
Normal operation gets started when any motion is detected.
Sensitivity setting
There are two gures in OSD "Sensitivity", the upper gures for Human Sensor, and
lower gures for Sensitivity.
Monitor judges there is no user when gures of Sensitivity is smaller than one of
Human Sensor.
Power save mode is activated when the status of "no user in front of monitor"
continues in a row more than your set time.
e.g.)
Make a monitor activate power save mode in the case that a user is not in front of a
monitor for ten minutes.
①
Appear OSD "Sensitivity" as below, check and note gures of Human Sensor in each
case that "user in front of a monitor" and "no user there".
- User in front of a monitor: 011
- No user in front of a monitor: 004
②
In the case of
①
, Sensitivity should be around 7, which is between "004" and "011".
③ Set "10" to Human Sensor.
In this setting, Power save mode is not activated as long as a user is in front of a
monitor, but it is activated after a user leaves for ten minutes.
Human Sensor
Setting
DP Power setting (Set up the power of DisplayPort)
Make set up power save status of this monitor by using power save of your
workstation.
On: Power save mode: mid
Monitor turns on synchronously when turning on your workstation from sleep
mode.
* When the human presence sensor is on, the power save mode is low. (
P38)
O
:
Power save mode: high
Monitor won’t turn on even though your workstation wakes up from sleep mode
when selecting “DisplayPort IN1”. Tap the stand-by key or the main switch.
By selecting
“DisplayPort IN2”
makes your workstation turn on automatically.