Projection Television Users Guide

44
Initial Setup
This TV has three color projection tubes: one for red, green, and blue. When mixed together
in the proper portions, the output of these three color tubes can produce any color. To produce
these colors, however, the beams must be precisely aligned over each other so that the colors
can be mixed. The produce of aligning these picture beams is called “convergence”.
Attention:
• Please have your TV on for at least 20 minutes before using this feature.
• This adjustment will be needed only when the colors of the characters/lines are separated
and lack in distinction. If not, please don’t perform the adjustment.
Colors may become separated after the TV has
been moved, or over a long period of time if regularly
subjected to low levels of vibrations. If the colors become
separated, please perform the adjustments below
again. In the beginning, please be sure to perform
AUTO convergence adjustment.
Press the M
ENU button
π† To CONVERGENCE
è To Enter
π† To select “AUTO” (The convergence adjustment
will start. It will take about 50 seconds).
When the adjustment is finished, it will return to
what you were watching.
Note:
• You can reset the adjustment if you do not like the results. See the next page.
• If you want to adjust it more, you can perform the manual color convergence adjustment.
See the next page.
• You can also access this feature by pressing the S
UPER FOCUS button on the front panel of
your TV.
CONVERGENCE
SELECT OPERATE EXIT
MENU
AUTO
MANUAL
RESET
Adjusting CRT Color Convergence
Auto
MENU CHANNEL VOLUME SUPER
FOCUS
OPERATE
– + – +
INPUT- 4
S-VIDEO VIDEO AUDIO
RL / MONO
OVER
OPEN
SUPER
FOCUS
SUPER FOCUS
AV-48\56P775\785 44 9/28/04, 11:19:17 AM