User's Manual

H. Notice.
Information on test modes and additional testing requirements
a) The modular transmitter has been fully tested by the module grantee on
the required number of channels,modulation types and modes, it should
not be necessary for the host installer to re-test all the available transmitter
modes or settings.It is recommended that the host product manufacturer
installing the modular transmitter,perform some investigative
measurements to confirm that the resulting composite system does not
exceed the spurious emissions limits or band edge limits(e.g.,where a
different antenna may be causing additional emissions).
b) The testing should check for emissions that may occur due to the
intermixing of emissions with the other transmitter, digital circuitry,or due
to physical properties of the host product(enclosure). This investigation is
especially important when integrating
multiple modular transmitters where the certification is based on testing
each of them in a stand-alone configuration. It is important to note that
host product manufactures should not assume that because the modular
transmitter is certified that they do not have any responsibility for final
product compliance.