Installation Guide

11/10/21, 12:29 PM

2006 Ford Fusion • MotoLogic

https://www.motologic.com/car/f16b6d20-ca4d-012b-1090-fbb1677812c1/article/687d6160-4549-012a-fa3c-f1daae012027?returnPath=%2Fcar%2Ff1

…

1/2

Report a problem with this article

Climate Control - Heater Core - Removal and Installation

SECTION 412-01: Climate Control 2006 Fusion/Milan/Zephyr Workshop Manual

REMOVAL AND INSTALLATION Procedure revision date: 06/30/2005

Heater Core

Item Part Number Description

1 W712320

Heater core cover screw (8 required)

2 18B300

Heater core cover

3 19C593 Dash panel seal

4 18476

Heater core

Removal and Installation

NOTE: If a

heater core leak is suspected, the heater core must be pressure leak tested before it is removed from the

vehicle. For additional information, refer to Section 412-00.

1. Remove the

heater core and evaporator core housing. For additional information, refer to Heater Core And

Evaporator Core Housing in this section.

2. Detach the wire harness from the heater core cover.

↻

PAGE 1
1/10/21, 12:29 PM 2006 Ford Fusion • MotoLogic Climate Control - Heater Core - Removal and Installation Report a problem with this article SECTION 412-01: Climate Control 2006 Fusion/Milan/Zephyr Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 06/30/2005 Heater Core ↻ Item Part Number Description 1 W712320 Heater core cover screw (8 required) 2 18B300 Heater core cover 3 19C593 Dash panel seal 4 18476 Heater core Removal and Installation NOTE: If a heater core leak is
PAGE 2
11/10/21, 12:29 PM 2006 Ford Fusion • MotoLogic 3. Remove the 8 heater core cover screws. 4. Remove the heater core cover. 5. Remove the dash panel seal from the heater core tubes. 6. Remove the heater core. 7. To install, reverse the removal procedure. https://www.motologic.