Instructions

Distance setting:
Use special tool check that the gap between
the glass slide/tilt sunroof panel and body is the
same.
009340
Slide special tool or similar between gasket
and insert. It must be possible to slide the card
against the same level of resistance.
009340
Slide glass slide/tilt sunroof panel towards front or
rear until ideal position is reached.
Adjusting glass slide/tilt sunroof panel at front:
Carry out the following step on one side first and then
the other (first left, then right or vice versa):
Loosely screw in Torx screws(1) on left/right
until glass slide/tilt sunroof panel(2) can just
still be shifted
Shift glass slide/tilt sunroof panel(2) as
required
Make sure all screws are tightened down.
Tightening torque:
54124AZ Type Thread
Tightening
specificati
ons
Dime
nsion
4
A
Z
Glass
slide/t
ilt
sunro
of
panel
to
mech
anics
R50 / R53
/ R56
Renew
screws.
4 Nm
R60 / R61
/ F54 /
F55 / F56
/ F60
M5x6
Renew
screws.
4,5
Nm
Repeat procedure on other side.