FLW062-Qi,FLW062B-Qi,FLW062BR-Qi
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Assembly Instructions TLW10-Qi,TLW10NA-Qi TLW10WA-Qi Page 1/3 (See last page for details on extending your warranty for free!)
Leg Table top Finial Shade Harp STEP 1 Insert the cord through the hole in the table. Secure it by fastening the nut. Plug the two parts of the wire together and screw to lock in place. A F B Secure the pole (F) to the table using the wingnut as shown above. Turn the table over and then screw each leg (A) to the table top as shown above.
C D E G Place the harp (E) on the socket holder and secure the lamp shade (D) to the harp using the finial (C).Use the cable tie (G) to secure the cord onto a leg (A). Wireless Charging Place your phone within the area indicated by the curved lines. When the light turns green, your phone has started to charge. (At first, you may need to slightly slide your phone until its battery lines up with the charging unit.
Assembly Instructions TLW09-Qi,TLW09B-Qi,TLW09BR-Qi (See last page for details on extending your warranty for free!)
Before beginning assembly, make sure you have all the parts: Allen key Screw Bolt Harp Socket & Pole Top board Posts Middle shelf Legs Bottom board Finial Clips EVA pads Shade Side panel 1 Side panel Posts Top board 2 Legs Middle shelf Bolt Screw each post (G) into a threaded hole on the top board (F). Using the bolts (C), connect each post (G) to the middle shelf (H) as shown above. Slide each side panel (O) into a slot on two posts (G).
STEP 4 STEP 3 EVA pads Bottom board K Insert the cord through the hole in the table. Secure it by fastening on the nut.Plug the two parts of the wire together and screw to lock in place. M A B Socket & Pole finial N clip N shade D J E L Secure the pole (E) to the table using the wingnut as shown above. Using Allen Key (A) and screws (B), secure the bottom board (J) to the leg (I). Place the harp (D) on the socket holder and secure the lamp shade (N) to the harp using finial (K).
TLW09B Madison Lampshade Assembly Instructions a:Panel 1PC c Ring b: Ring 1PC 1PC 1. 2. 1. Please note that the bottom off the shade is longer than the top. Align the shade’s longer 2. Roll both rings all the way around side with Ring C and the shorter side with and make sure all the clips on the Ring B. Clip the pieces on the bottom and top shade are secure onto both Rings. of the shade to both Rings. 3. 3. Secure the shade by pressing along the magnet. 4. 4. Finished as above picture.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
