IMPRESSA E80/85 Art. Nr.
JURA IMPRESSA E80/85 Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. = Note = Important = Tip JURA Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www.jura.
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 14 Fig. 15 2 1 3 Fig. 11 Fig. 12 Fig. 13 Fig. 16 Fig.17 Fig.
Control elements 12 1. Rotary Switch 2. Illuminated ring 3. Programming key 4. Draw-off key 2 cups 13 5. Powder coffee selection key 6. Draw-off key 1cup 7. Steam pre-selection key 11 10 9 8 7 6 5 4 3 14 8. ON/OFF key 9. Maintenance key 10. Display dialog system 15 11. Water tank with carrying handle 12. Filler funnel for pre-ground coffee 13. Bean tank cover 14. Aroma preservation cover 16/17 18 19 15. Steam/hot water water draw-off valve 16. Replaceable 2-stage frothing jet see fig.6 17.
Contents JURA IMPRESSA E80/85 1. Safety information..........................................page 1.1 Warning ..............................................page 1.2 Precautions ..........................................page 2. Preparing the IMPRESSA E80/85 .....................page 2.1 Check supply voltage ..............................page 2.2 Check electrical fuse ..............................page 2.3 Fill water tank......................................page 2.4 Fill coffee beans.........................
Introduction 1.2 Precautions Thank you for purchasing the IMPRESSA E80/85. To ensure perfect functioning of your IMPRESSA E80/85, carefully read this operating manual and keep it for future reference. Should you need more information or if you encounter particular problems not specified in these operating instructions in sufficient detail, either contact us directly or contact your local authorized dealer.
2.3 Fill water tank Only use fresh, cold water. Never fill in milk, mineral water or other liquids. Remove the water tank and rinse it with cold tap water thoroughly (Fig. 4). Then fill the water tank and reinstall it. Make sure to install the tank properly, it must engage audibly. 2.
Fill the water tank (11) with fresh water. OPEN TAP Place an empty cup under the replaceable hot water nozzle (17). Open the steam / hot water draw-off tap (15) (Fig. 13). FILLING SYSTEM SHUT TAP Close the steam / hot water draw-off tap (15). HEATING PRESS RINSE Press the maintenance key (9). Machine carries out a rinsing operation. RINSING READY If BEANS FILL is displayed, press the coffee draw-off key again. Machine not filled with coffee beans yet.
Press the Rotary Switch (1) to confirm the required level. HARDNESS Press the programming key (3) to quit the programming mode. READY 5. Installation of CLARIS plus filter cartridges If the CLARIS plus filter cartridge is installed properly, de-scaling of the coffee machine is no longer required. For more information on the CLARIS plus filter cartridge refer to brochure «CLARIS plus. Hard on limescale. Gentle on your coffee machine.» 5.1 Installing the filter Fold up the cartridge holder.
RINSING FILTER SHUT TAP Close the steam / hot water draw-off tap (15). HEATING READY 5.3 Replacing the filter without display request Rinsing, cleaning, de-scaling and filter replacement can also be started without the corresponding request of your IMPRESSA E80/85, if necessary, directly from the maintenance menu.
8. Drawing off 1 cup of coffee You can increase the strength of your coffee at any time during the grinding operation by pressing the 1 cup drawoff key again. For Example: Press the 1 cup draw-off key three times to get a strong coffee STRONG Your product is being prepared. READY 9. Drawing off 2 cups of coffee Selecting the coffee strength is not possible when drawing off 2 cups of coffee. You will draw off 2 mild cups automatically. You can choose among three strengths at the push of a button.
10. Drawing off pre-ground coffee Never use instant coffee or quick-coffee. We recommend that you always use powder from fresh coffee beans or, preground, vacuum-packed coffee. Never fill in more than 2 portions of powder. The pre-ground coffee tank is no storage tank. Make sure that the pre-ground you use is not too fine. This may cause blocking of the system. In this case the coffee only drips out of the coffee spout. POWDER Your product is being prepared. READY 11.
Before CLOSE TAP water may still escape the system. 12. Drawing off steam To ensure perfect operation, clean the 2-stage frothing jet (16) regularly. Screw the jet off as described. Hold the jet at the top and at the bottom end and screw it apart (Fig. 18). Thoroughly rinse the 3 parts under running water. Make sure the nozzle has engaged properly. If the nozzle is clogged with dried milk or has not been attached properly, it might suddenly come off during operation.
13.1 Connecting the Professional Cappuccino Frother to your IMPRESSA E80/85 Disassemble the replaceable hot water jet (Fig. 5) or the replaceable 2-stage frothing jet (Fig. 6). Mount the Professional Cappuccino Frother (Fig. 7) Press one side of the hose into the opening behind the dial (Fig. 10) The optionally available milk container can be used for sucking in milk. How to connect it (see Fig. 8). 13.
Stats Language ML / OZ Rinse Programming key (3) Use the programming key (3) to open or quit the programming mode (no saving of values effected). Rotary Switch (1) Turn the Rotary Switch (1) to change the adjusted values or to select the next programming step. Press the Rotary Switch (1) to check the values adjusted or to save the values selected 15.1 Programming the filter Refer to Chapter 5.1 «Installing the filter». 15.
Press the programming key (3) to quit the programming mode or select the next programming item using the Rotary Switch (1). READY 15.5 Cup counter You can check how many cups of the following coffee products were drawn off: a) 1 cup b) 2 cups c) Powder coffee READY Press programming key (3) until FILTER – is displayed. The illuminated ring (2) is active. Turn the Rotary Switch (1) until STATS is displayed.
ML Turn the Rotary Switch (1) until the message OZ is displayed. To confirm the new setting, press the Rotary Switch (1) OZ Press the programming key (3) to quit the programming mode or select the next programming item using the Rotary Switch (1) READY 15.8 Switch-off rinsing operation The switch-off rinsing operation of your IMPRESSA E80/85 is activated when the machine leaves the factory. In special cases it can be deactivated. For more information, contact your local customer service. 16.
16.5 Replacing the filter After drawing off 50 litres, the filter cartridge will be used up. A message requesting you to replace the filter will appear on the display. Refer to Chapter 5.2 «Replacing the filter». 16.6 General cleaning instructions Never use scratching objects, pan cleaners, cleaning sponges or caustic chemicals to clean the machine. Wipe off the case on the inside and outside using a soft, moist cloth. Clean the replaceable hot water jet after each use.
Empty the drawer DRAWER MISSING Insert the drawer again. Remove the drip grate (20). Put a container (1/2 l, Fig. 12) under the adjustable coffee spout (18). PRESS RINSE Press the maintenance key (9). CLEANING ADD TABLET Fill in the tablet (see Fig. 15) PRESS RINSE Press the maintenance key (9). CLEANING EMPTY DRAWER DRAWER MISSING READY The cleaning operation was completed successfully. 17.
EMPTY DRAWER Empty the drawer DRAWER MISSING Insert the drawer again. SOLVENT IN TANK Completely dissolve the content of one blister (3 tablets) in a jug containing 0.5 litres of water, and fill the mixture in the water tank. Reinstall the water tank. SOLVENT IN TANK OPEN TAP Put a sufficiently large container under the replaceable hot water nozzle (17). Open the steam / hot water draw-off valve (15) (Fig.
19. Disposal Please return the IMPRESSA E80/85 machine to your local dealer, the service shop or to JURA for proper disposal. 20. Tips for perfect coffee Height-adjustable coffee spout (18) You can adjust the height of the coffee spout to the size of your cups (Fig. 3) Grinding degree Refer to Chapter 2.5 «Adjusting the grinding gear». Preheating cups You can preheat the cups using hot water or steam. The smaller the coffee you want to draw off, the more important preheating is.
21. Messages Cause Remedy Water tank is empty. Refill water Float defective Rinse or de-scale water tank Bean tank is empty. Refill beans Although you have refilled beans, the message still appears. Draw off a cup of coffee. The message will disappear only after you have drawn off a cup of coffee Coffee grounds container full Empty coffee grounds container Tray reinstalled too early after emptying Wait 10 sec.
22.
23. Legal information 24. Technical data These operating instructions contain all the information required for using, operating and maintaining the machine properly. Knowledge of and compliance with the specifications contained in these operating instructions is required for using the machine safely as well as for operational safety and safety during maintenance. These operating instructions cannot cover any conceivable application. The machine was designed for private household use.
