User Manual

S0-738 User Manual PAGE：
4 43-S0-738 User Manual DATE:10-14-2008
38
ISO 9001 Certified
台揚企業集團
MTI Group.
台揚集團智慧財產
任何未經授權逕予複製、重製、公開或使用本文之行為，將被視為侵害
台揚集團之智慧財產權，將可因此負擔法律責任。
MTI Group Proprietary Information
Any unauthorized use, duplication, reproduction, or disclosure of this document may be
considered as infringement of MTI Group’s intellectual property rights, the infringer ma
y
be accused and liable applicable legal penalties.
RADIUS Remote Authentication Dial In User Service
RSSI Received Signal Strength Indication
RTS Request To Send
SNMP Simple Network Management Protocol
SSH Secure SHell
SSID Service Set IDentifier
SSL Secured Sockets Layer
TKIP Temporal Key Integrity Protocol
URL Universal Resource Locator
WEP Wired Equivalent Privacy
WPA Wi-fi Protected Access
9.3 Frequently Asked Questions and Answers
Can not configure the AP
¾ Please check the power indicator light AP positive normal；
¾ Please check the use of computer communications port Ethernet link lights are in working order；
¾ Please check your computer's network settings, verify that all TCP / IP settings are correct.
System in Windows 98/ME, you can at MS-DOS mode, type winipcfg command; in the Windows
NT/2000/XP system, you can at MS-DOS mode, type the ipconfig command, check whether the
computer's IP address and IndoorAP Nets are belong to the same paragraph; computer's IP
address should be between 192 range.168.0.2 to 192.168.0.254.
¾ If your operating system to Windows XP, make sure that "Network Connection" Whether or not
there is in "bridge" configuration, if any, be sure to delete this set。
AP has been successfully connected ISP (from the "Device Information" interface, as shown in
the connection status information to know), but I still can not browse Internet
。
¾ Please check your computer's IP address is correct, the computer's IP address and products should
be in the same network segment；