JUN-X8 DC Battery Charger Manual

Mini Balance Charger/Discharger/DC Power

- 30 -

Select the test mode and go to the following corresponding interface.

Pulse Measurement

Connect the signal receiver or transistor with the multifunctional port like below, which can measure their pulse signal:

Select SYSTEM MENU→Extra Function→Pulse Test to enter the pulse test interface

Monitor Setup

Select SYSTEM MENU→Extra Function→Monitor Settings to enter the manage interface.

Liner Test: When turning the knob,

the pointer deflects with the setting

value of Step, and the servo responds

accordingly.

Fixed Point Test: When turning the

knob, the pointer deflects among

each setting value and the servo

responds accordingly.

Auto CW/CCW Test: Click Test

button then the pointer deflects the

setting times at a set rate back and forth

among each setting values, and the

servo responds accordingly.

Monitor Log Interval: 1Sec

After ticking Log of monitor save to SD

card, the log will be saved to SD card

automatically.

Signal Receiver or

Transistor