Specification

One Lithonia Way | Conyers, GA 30012 | Phone [phone]-SERV (7378) | www.acuitybrands.com
© 2021 Acuity Brands Lighting, Inc. All rights reserved. Rev. 06/17/21 Page 2 of 2
CONTRACTOR SELECT WF4C_WF6C
HOUSING:
Polycarbonate injection molded outer frame, with steel back plate. Non-conductive dead-front
trim design suitable for a wide range of applications and codes requiring a non-conductive
lens • FT4 3-pin plenum rated cable connector to connect from module to remote driver box
• Steel spring clip for easy installation. 4" or 6" cut out template is provided to ensure a
correct sized hole is cut into ceiling for proper installation of the trim. Size of hole should
not exceed 4 1/4 inches (WF4C) or 6 1/4 inches (WF6C) for this product • Can be installed
from 3/8" to 1 ½" ceiling thickness • Can be removed from below the ceiling for service or
replacement.
LED LIGHT ENGINE:
LEDs are integrated to one piece high purity aluminum, thermally conductive housing to
provide uninterrupted heat transfer to ensure long life of the LED
• Tunable color temperature from 2700K to 5000K • 90 CRI minimum
• Dimmable to 1%
DRIVER:
Dedicated 120 volt replaceable driver • Accommodates 120 volts AC at 50/60Hz • Isolated
driver integrated inside steel remote box with four 7/8” knockouts with slots for pryout
• Suitable for pulling wires with the 12 cubic-inch wiring compartment to accommodate up to
(6) 14 gauge insulated conductors; making the Wafer LED Downlights much easier to wire in
2in/2out (plus ground) daisy-chain applications and contractor friendly • Designed to provide
50,000 hours of life • 3-year warranty on LED components.
LIFE:
Rated for 50,000 hours at 70% lumen maintenance.
LABELS:
CSA certied to US and Canadian safety standards • ENERGY STAR® certied product
• Suitable for wet location • Air-Loc certied in accordance with ASTM E283-2004 • NOM
Certied • Can be used to comply with California Title 24 Part 6 High Efcacy LED light Source
Requirements.
TESTING:
All reports are based on published industry procedures; eld performance may differ from
laboratory performance.
WARRANTY:
3-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/support/warranty/terms-and-conditions
Note: Actual performance may differ as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specications subject to change without notice.
Specifications Dimensions
4.9"
5.9"
6.7"
1.1"
4"
4.7"
1.1"
3.2"
WF4C
WF6C