Specification

One Lithonia Way • Conyers, GA 30012 • Phone [phone]-SERV (7378) • Visit us at www.acuitybrands.com
Printed in U.S.A. ©2020 Acuity Brands Lighting, Inc. Rev. 12/10/20
3 of 5
Juno Wafer
™
LED Downlight Series
6" LED Ultra-Thin Wafer Switchable Downlight
970 Lumen
Light Commercial & Residential
WF6 SWW5
Specifications
Housing
Polycarbonate injection molded outer frame, with steel back plate. Non-
conductive dead-front trim design suitable for a wide range of applications
and codes requiring a non-conductive lens • FT4 3-pin plenum rated cable
connector to connect from module to remote driver box.• Steel spring clip for
easy installation. 6" cut out template is provided to ensure a correct sized hole
is cut into ceiling for proper installation of the trim. Size of hole should not
exceed 6 ¼ inches for this product. Can be installed from 3/8" to 1 ½" ceiling
thickness • Can be removed from below the ceiling for service or replacement
LED Light Engine
Switchable white color temperature from 2700K, 3000K, 3500K, 4000K,
5000K • 90 CRI minimum • Color accuracy within 4 step McAdams Ellipse
at the end CCT (2700K and 5000K), within 6 step McAdams Ellipse in the
middle CCT (3000K, 3500K, and 4000K) • Dimming 100% to 10% with
most standard incandescent dimers (see list of approved dimmers).
Driver
Connect directly to 120V Class-2 (CAN ICES-005 (B) / NMB-005 (B)) LED
driver. 120V 60 Hz constant current driver provides noise free operation
• IC rated driver with convenience of a switch to choose between 5 selectable
color temperature options ranging from 2700K (warm white), 3000K, 3500K,
3000K, 4000K, or 5000K (daylight) • The isolated driver integrated inside
steel remote box with four 7/8" knockouts with slots for pryout. Suitable for
pulling wires with the 12 cubic-inch wiring compartment to accommodate
up to (6) 14 gauge insulated conductors; making the Wafer LED Downlights
much easier to wire in 2in/2out (plus ground) daisy-chain applications and
contractor friendly • 2" plenum space required for installation of the remote
driver box.
Optical System
Edge-lit LED technology uses light guided plate to distribute light • Polycarbonate
lens provides even illumination throughout the space • Efficient system that can
produce over 970 lumens while using 13W • Replaces 75W incandescent.
Life
Rated for 50,000 hours at 70% lumen maintenance.
Labels
CSA certified to US and Canadian safety standards • ENERGY STAR
®
certified product • Suitable for wet location • Air-Loc certified in accordance
with ASTM E283-2004 • NOM Certified • Can be used to comply with
California Title 24 Part 6 High Efficacy LED light Source Requirements • U.S.
Patent No. 10,681,784.
Testing
All reports are based on published industry procedures; field performance
may differ from laboratory performance.
Warranty 3-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Specifications subject to change without notice.