Specification

One Lithonia Way • Conyers, GA 30012 • Phone [phone]-SERV (7378) • Visit us at www.acuitybrands.com
Printed in U.S.A. ©2020 Acuity Brands Lighting, Inc. Rev. 10/5/20
3 of 5
Light Commercial & Residential
Juno Wafer
™
LED Downlight Series
6" LED Regressed Wafer Switchable Downlight
950 Lumens
WF6 REG SWW5
Specifications
Housing
Die cast aluminum mounting frame with integral polycarbonate flange provides
passive thermal cooling achieving L70 at 50,000 hours • Lens regressed to .5"
with baffle trim design to reduce glare for comfortable and even illumination
• FT4 3-pin plenum rated cable connector to connect from module to remote
driver box • Steel spring clip for easy installation. 6" cut out template is provided
to ensure a correct sized hole is cut into ceiling for proper installation of the trim.
Size of hole should not exceed 6 ¼ inches for this product. Can be installed
from 3/8" to 1 ½" ceiling thickness • Can be removed from below the ceiling
for service or replacement.
LED Light Engine
LEDs are integrated to one piece high purity aluminum, thermally conductive
housing to provide uninterrupted heat transfer to ensure long life of the LED
• Switchable white color temperature from 2700K, 3000K, 3500K, 4000K,
5000K • 90 CRI minimum • Color accuracy within 4 step McAdams Ellipse
at the end CCT (2700K and 5000K), within 6 step McAdams Ellipse in the
middle CCT (3000K, 3500K, and 4000K) • Dimming 100% to 10% with
most standard incandescent dimers (see list of approved dimmers).
Driver
Connect directly to 120V Class-2 (CAN ICES-005 (B) / NMB-005 (B)) LED
driver. 120V 60 Hz constant current driver provides noise free operation •
IC rated driver with convenience of a switch to choose between 5 selectable
color temperature options ranging from 2700K (warm white), 3000K, 3500K,
3000K, 4000K, or 5000K (daylight) • The isolated driver integrated inside
steel remote box with four 7/8" knockouts with slots for pryout. Suitable for
pulling wires with the 12 cubic-inch wiring compartment to accommodate
up to (6) 14 gauge insulated conductors; making the Wafer LED Downlights
much easier to wire in 2in/2out (plus ground) daisy-chain applications and
contractor friendly. • 2" plenum space required for installation of the remote
driver box Edge-lit LED technology uses light guided plate to distribute light.
Optical System
• Polycarbonate lens provides even illumination throughout the space • Efficient
system that can produce over 950 lumens while using 13W • Replaces 75W
incandescent.
Life
Rated for 50,000 hours at 70% lumen maintenance.
Labels
CSA certified to US and Canadian safety standards • ENERGY STAR
®
certified product • Suitable for wet location • Air-Loc certified in accordance
with ASTM E283-2004 • NOM Certified • Can be used to comply with
California Title 24 Part 6 High Efficacy LED light Source Requirements • IP5X
Rated, product is protected against dust. U.S. Patent No. 10,681,784.
Testing
All reports are based on published industry procedures; field performance
may differ from laboratory performance.
Warranty 5-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Specifications subject to change without notice.