Use and Care Guide

ULH-DWM Direct Wire Module Installation Instructions
For use with Juno ULH Series Undercabinet Fixtures
Technical Services Department
Phone: [phone] (Toll Free)
Fax: [phone]
1300 S. Wolf Road
PO Box 5065
Des Plaines, IL 60017-5065
© 2004 JUNO lighting, inc.
220 Chrysler Dr.
Brampton, Ontario
Canada, L6S 6B6
This Direct Wire Module is for use with Juno ULH Series undercabinet fixtures. This Module is designed to
be wired with Flat Non-Metallic Cable (NMB) (2C+Ground), or Flexible Metal Conduit (BX).
NOTE! Electrical connector for BX installations is supplied with fixture or may be purchased separately.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1. Read all instructions before beginning installation.
Safely store these instructions for future reference.
2. This module is for use with Juno ULH fixtures and
accessories. Do not use this module or the provided
jumper cord with any other products.
3. WARNING: FOR MULTIPLE FIXTURE INSTALLATIONS,
MAKE CERTAIN FIXTURES ARE CONNECTED TO BRANCH
CIRCUIT AT ONLY ONE FEED POINT.
4. CAUTION: Do not exceed 5 AMPS maximum load
5. For use with 120V 60Hz. power supply only.
For interior use only.
6. WARNING: DO NOT ELECTRIFY THE MODULE UNTIL
THE FOLLOWING CONDITIONS HAVE BEEN MET:
a. MOUNTING AND WIRING OF MODULE IS COMPLETE.
b. THE MODULE COVER HAS BEEN INSTALLED
WITH SCREWS & LOCKWASHERS SECURELY
FASTENED.
c. ALL FIXTURES CONNECTED TO MODULE HAVE
BEEN MOUNTED AND THEIR DIFFUSERS /
LENSES HAVE BEEN PROPERLY INSTALLED.
d. ALL OPEN ELECTRICAL PORTS ON CONNECTED
FIXTURES ARE COVERED WITH ELECTRICAL
PORT COVERS PROVIDED WITH THE FIXTURES.
7. WARNING: TO PREVENT OVERHEATING DO NOT
INSTALL IN SMALL ENCLOSED SPACES. TO PREVENT
ELECTRICAL SHOCK DO NOT INSTALL IN WET
ENVIRONMENTS.
8. Qualified electricians, in accordance with local electrical
codes, should perform all installations.
9. Fixtures may be dimmed using quality household
dimmers or dimmer systems designed for non-
inductive loads. For best dimming performance, use
dimmer systems specifically designed for low voltage
electronic transformers.
10. Always disconnect electrical power from this product
before cleaning or servicing.
11. Do not operate this product if jumper cord has been
damaged.
12. Keep jumper cord away from sources of heat and
heated surfaces.
13. Do not operate this product in environments where
aerosol sprays are being used or where oxygen is being
administered.