Operating Guide

REV-2/09
DIMENSIONS
6” DELUXE UNIVERSAL
TC HOUSING
INCANDESCENT LAMPS
TC2
G1.1.1
Project:
Fixture Type:
Location:
Contact/Phone:
7 1/2"
13 1/2"
Will expand
to 25"
(Reduces to 8 1/8"
with breakaway
feature)
9 1/2"
7 1/2"
13 1/8"
PRODUCT CODES
Catalog Number Input Voltage Lamp Rating (max.)
TC2 120V A19/A21/BR30/BR40/MR16/PAR16/PAR20/PAR30/PAR30L/PAR38/R20/R30 (See reverse for max. trim rating)
PRODUCT DESCRIPTION
TC Housing design for use in non-insulated areas • If installed
where insulation is present, the insulation must be pulled back 3”
from all sides of the TC housing.
PRODUCT SPECIFICATIONS
Lamp Lamp ratings based on trim selected–see reverse.
Socket Medium base porcelain with nickel-plated copper screw
shell • Drop socket with spring to accommodate certain trim
installation.
Trims Trim selection shown on reverse.
Labels U.L. listed for through-branch wiring, damp locations and
IP • Product thermally protected against improper use of lamps or
insulation • Union made • UL Listed/CSA certified • Trims 20,
21, 22, 239, 240, 241, 242, 243 and 9900 are wet location
approved for covered ceiling applications • Trims 28, 29 are wet
location approved for covered ceiling applications, when used
with outdoor rated lamps.
Testing All reports are based on published industry procedures;
field performance may differ from laboratory performance.
Product specifications subject to change without notice.
INSTALLATION
Real Nail 3 Bar Hangers Telescoping, patent-pending Real Nail 3
system permits quick placement of housing anywhere within 24”
O.C. joists or suspended ceilings • Integral T-bar notch and clip
secures housing in suspended ceiling grid – no accessory clips
required • 24” expansion stop allows quick placement of fixture in
standard grid spacing • Bars scored in two locations for fast,
clean breaking, allowing housing installation in tight applications
• Bars captive to mounting frame • Edge-mounted for extra
strength • Captive bugle-headed ring shank nail for quick one-step
installation and easy removal with claw hammer for fixture
relocation • Quick-Loc slot (location identified on the mounting
frame) and oversized locking set screw lock fixture in position
• Bar hanger foot contoured to align to bottom of construction joist
• Alternate mounting holes included.
Junction Box Pre-wired junction box provided with (5)
1
⁄2” and
(1)
3
⁄4” knockouts, (4) Non-metallic sheathed cable connectors and
ground wire, U.L. listed/CSA certified for through-branch wiring,
maximum 8 No. 12 AWG 90˚ C branch circuit conductors (4 in,
4 out) • Junction box provided with removable access plates
• Knockouts equipped with pryout slots.
Mounting Frame 22-gauge die-formed galvanized steel
mounting frame • Rough-in section (junction box, mounting frame,
housing and bar hangers) fully assembled for ease of installation
• Sight lines embossed on mounting frame to allow for easy
viewing when aligning fixtures.
Housing TC housing, 22-gauge white painted steel • Housing is
vertically adjustable to accommodate up to a 2” ceiling thickness.
6 7/8” CEILING CUTOUT