Installation Guide

One Lithonia Way · Conyers, GA 30012 · Phone [phone]
Visit us at www.acuitybrands.com/juno-recessed
© 2022 Acuity Brands Lighting, Inc.
912-00416-000 REV A
DATE 12/2022
PAGE | 3
INSTALLATION INSTRUCTIONS
Juno RetroBasics™ 4” & 5/6” LED Adjustable Trim Kit - RBA Series
Do not operate fixture at temperatures higher than
this.
• Unless individual product specifications deem
otherwise: Never mount in places where fixture will
be exposed to rain, high humidity, extreme
temperature changes or restricted ventilation.
• LED products are Polarity Sensitive. Ensure proper
Polarity before installation.
• Electrostatic Discharge (ESD): ESD can damage
LED fixtures. Personal grounding equipment must be
worn during all installation or servicing of the unit.
• Do not touch individual electrical components as this
can cause ESD, shorten lamp life, or alter
performance.
• There are no user serviceable parts inside the unit.
Do not rewire, reconfigure, or modify the unit or
attempt any repairs yourself. Additionally, field
replacement of the LED assembly or lamps is not
allowed by UL standards at this time. In the unlikely
event your unit may require service, stop using the
unit immediately and contact an ABL representative.
• CAUTION RISK OF WIRING PRODUCT DAMAGE
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
All luminaires that contain electronic devices that generate frequencies above 9kHz from any component within the luminaire comply
with one of the following Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation.
Juno LED Trim Kit Compatibility in Recessed Cans
Juno LED Trim Kits are designed to work with most standard UL listed
recessed incandescent housings. When used with standard medium base
incandescent housings, the medium base socket adaptor must be used.
Housing compatibility can be determined by measuring the recessed
housing diameter and height as shown in the diagram. Refer to the chart for
compatible size ranges. Housing construction features vary. The height and
diameter chart should be used as a guideline. Actual installation is the best
method of determining compatibility.
RB 4"
RB 5/6"
Internal Diameter
4" min
5" min
Internal Height
3.47" min
4" min
Trim Flange Diameter
5.25"
7.6"