Installation Guide

R25 T-Connector
(can also use as electrical feed from Junction Box)
Joins three Trac sections in a T intersection.
1. Make sure main power is OFF.
2. Insert T-Connector fully into Juno Trac with polarity arrow pointing
toward Trac polarity line. Secure with set screws.
3. Attach Trac to ceiling following instructions supplied with the Juno
Trac section.
For using T Connector to power Trac from a Junction Box:
1. Attach Juno Junction Box Cover T27 (not supplied) to T-Connector.
a. Punch out screw holes from Junction Box Cover T27.
b. Remove T-Connector cover.
c. Secure T-Connector flush to Junction Box Cover T27
using nipple and locknuts supplied with Junction Box Cover.
2. Insert feed connector fully into Trac with polarity arrow pointing toward
Trac polarity line. Secure with set screw.
3. Attach Trac to ceiling (or wall) following instructions supplied with
the Trac section.
4. Pull junction box wires through Junction Box Cover nipple.
5. Secure Junction Box Cover/T-Connector assembly to existing junction
box using screws supplied with Junction Box Cover.
6. Fasten positive wire to screw terminal marked “P”.
7. Fasten white wire (neutral) to screw terminal marked “N”.
8. Replace T-Connector cover and secure with screw.
T25
Set Screws
Cover
Polarity Line
Polarity Arrow
R25 T-Connector
Existing
Junction Box
(not Included)
Screws
J-Box Mounting
Strap
Ground
Screws
Locknut
Cover
Terminal
Screws
Set
Screw
Polarity
LIne
Polarity
Arrow
Feed
Connector
R21 End Feed
R21 End Feed
(for use only with junction box)
Makes electrical connection at standard Junction Box. Use at end of Trac run.
1. Make sure that power is OFF.
2. Pull wires through mounting strap hole. Attach mounting strap to existing
junction box with enclosed screws.
3. Insert feed connector fully into Trac with polarity arrow pointing toward
Trac polarity line and secure with set screw.
4. Attach Trac to ceiling (or wall) following instructions supplied with
the Trac section.
5. Pull junction box wires through feed connector and nipple.
6. Secure feed connector to mounting strap with lock nut and
nipple provided.
7. Fasten positive wire to screw terminal marked “P”.
8. Fasten white wire (neutral) to screw terminal marked “N”.
9. Connect ground wire to ground screw.
10. Replace cover and secure with screw.
For Juno R Series Trac Connectors, Electrical Feeds and Accessories
INSTALLATION INSTRUCTIONS
Exisiting
Junction Box
(not Included)
Junction Box
Cover T27
T-Connector
Locknut
(supplied with T27)
Nipple
(supplied with T27)
Locknut
Screws
(supplied with T27)
2 of 4
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone [phone] • Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc. Rev 3/17 P3069