Installation Guide

INSTALLATION INSTRUCTIONS

JUNO TYPE MINI LED RECESSED HOUSING

MD1 – MINI DOWNLIGHTS

MG1 – MINI GIMBALS

Step 5. Make certain no bare conductors are exposed after

attachment to terminals. Replace terminal block cover when wiring

is completed.

Step 6. Fixtures may also be daisy-chained by routing Class 2

12V AC wiring from fixture to fixture (Refer to wiring diagram).

Always connect cable wires to adjacent terminals on the far right or

far left side of the terminal blocks. Tighten all terminal block screws

to 4 In-lb minimum.

Step 7. Push excess wire into opening in mounting surface,

displace fixture coil springs as shown, (Fig. 4) insert fixture into

opening. Springs will recoil to hold fixture in place. Make certain

wires are contained behind the mounting surface and not damaged

in any way.

Step 8. Gimbal fixtures may be adjusted to direct light as desired.

Remove fixture from mounting surface, adjust light aiming by

rotating lower housing to desired position and re-install. Make

certain wires are not twisted or damaged as a result of the

re-aiming.

Step 9. Complete installation of all fixtures before restoring

electrical power.

Figure 4

DAISY-CHAINED FIXTURE(S)

(OPTIONAL)

WARRANTY

Juno Lighting Group provides five year limited warranty on LED components from date of purchase. Juno Lighting Group’s obligation

is expressly limited to repair or replacement, without charge, at Juno Lighting Group’s factory after prior written return authorization has

been granted. This warranty shall not apply to products which have been altered or repaired outside of Juno Lighting Group’s factory.

This warranty is in lieu of all other warranties, expressed or implied, and without limiting the generality of the foregoing phrase, excludes

any implied warranty of merchantability. Also, there are no warranties which extend beyond the description of the product on the

company’s literature setting forth terms of sale.

1300 South Wolf Road • Des Plaines, IL 60018

PHONE (847) 827-9880 • FAX (847) 827-2925 • www.junolightinggroup.com

WIRING DIAGRAM

MINI LED DOWNLIGHT OR GIMBAL FIXTURE

12V SECONDARY LEADS

CLASS 2

12V AC OUTPUT

TRANSFORMER