JKI 4053 JKI 4063 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS 2222 340-24
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. See defrost instructions. ¥ Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation ¥ During normal operation, the condenser and compressor at the back of the appliance heat up considerably.
Temperature regulation Fresh food refrigeration The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings.
HINTS Hints for refrigeration Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer. For safety, store in this way only one or two days at the most. Cooked foods, cold dishes, etc..: these should be covered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided.
CUSTOMER SERVICE AND SPARE PARTS opening is not obstructed (see ÒDefrostingÓ section). If the appliance is not functioning properly, check that: ¥ the plug is firmly in the wall socket and the mains power switch is on; ¥ there is an electricity supply (find out by plugging in another appliance); ¥ the thermostat knob is in the correct position.
It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 50 540 B 540 mm T H PR01 Apply joint the sealing strip as shown in figure. D765 Slide the appliance into the recess, pushing it against the wall on the handle side. A D022 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance.
Apply covers (B) on joint cover lugs and into hinge holes. B D726 Separate parts A, B, C, D as shown in the figure B A C D PR266 50mm Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. A 20m m PR166 Fix cover (C) on guide (A) until it clips into place.
Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ¿ 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. 8mm A PR167 B Should the lining up of the furniture door be necessary, use the clearance of slots.
