JKI 3433 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS 2222 292-53
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. See defrost instructions. ¥ Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation ¥ During normal operation, the condenser and compressor at the back of the appliance heat up considerably.
USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the ÇOÈ (STOP) position. The appliance will start to operate.
Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D351 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. PR187 HINTS Hints for refrigeration ¥ the freezing process takes 24 hours.
etc.) in the freezer compartment as they may burst. ¥ be sure that frozen foodstuffs are transferred from the foodstore to the freezer in the shortest possible time; Hints for storage of frozen food ¥ not open the door frequently or leave it open longer than absolutely necessary. To obtain the best performance from this appliance, you should: ¥ Once defrosted, food deteriorates rapidly and cannot be refrozen. ¥ ¥ Do not exceed the storage period indicated by the food manufacturer.
The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty.
auto-transformer must be used. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E.E.C.
Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D727 Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet.
Open both the appliance door and that of the kitchen unit to approx. 90¡. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. 8mm PR34 Remove the little plates and make the holes with a diam. of 2 mm. Replace the little platee over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes.
