JKI 2435 JKI 1040 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION D t 2222748-64
t CONTENTS Instructions for the user Instructions for the installer Important Safety Instructions 16 Technical specifications 22 Description of the appliance Use 17 18 Installation 22 Cleaning the interior Starting-up Temperatur control Fresh food refrigeration Freezing fresh food Storage of frozen food Thawing Ice-cube production Movable shelves Positioning the door shelves Hints Hints for refrigeration Hints for freezing Hints for storage of frozen food Maintenance Defrosting Periodic cleanin
IMPORTANT SAFETY INSTRUCTIONS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
t Installation ■ ■ ■ ■ ■ Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. ■ During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant paragraph.
USE Cleaning the interior Freezing fresh food Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The 4-star compartment ( ) is suitable for long term storage of commercially frozen food and for freezing fresh food.
t Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 D302 Positioning the door shelves To permit storage of food packages of various sizes, the central door shelf can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
Hints for freezing To help you make the most of the freezing process, here are some important hints: ■ the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; ■ the freezing process takes 24 hours.
t The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; 2.
CUSTOMER SERVICE AND SPARE PARTS If the appliance is not functioning properly, check that: the plug is firmly in the wall socket and the mains power switch is on; To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom lefthand side.
t This appliance complies with the following E.E.C. Directives: - 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications; - 87/308 EEC of 2.6.87 relative to radio interference suppression and subsequent modifications; - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications. Door reversibility The appliance’s door has been locked in position for transport by means of pins on both sides.
Instructions for totally built-in appliances Dimensions of the recess Height of housing Depth of housing Width of housing A mm 880 mm 550 mm 560 50 540 0 56 55 0 880 D022 3. Slide the appliance into the recess, pushing it against the wall on the handle side. PR 32 50 mm min. 200 cm 2 1. It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 540 mm D C D727 min. 200 cm 4.
t B A 8mm C D PR266 A 6. Separate parts A, B, C, D as shown in the figure. PR167 B 50mm 9. Open the appliance door and the furniture door at 90°. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with Ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. A 20m m PR166 7.
