JKI 2035 JKI 1000 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION D t 2222745-87
CONTENTS Instructions for the User Instructions for the Installer Important Safety Instructions 13 Technical specifications 18 Description of the Appliance 14 Installation 18 Use 15 Cleaning the interior Starting-up Temperature control Fresh food refrigeration Movable shelves Positioning the door shelves Hints Hints for refrigeration Maintenance Defrosting Periodic cleaning Periodic of non-operation Interior light Customer service and spare parts Positioning Electrical connection Door revers
IMPORTANT SAFETY INSTRUCTIONS t It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
■ ■ ■ ■ During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant paragraph. Attention: keep ventilation openings clear of obstruction. If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit.
t USE Cleaning the interior Fresh food refrigeration Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The refrigerator compartment is suitable for cooling drinks and for normal food storing.
Positioning the door shelves To permit storage of food packages of various sizes, the central door shelf can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. For more thorough cleaning, the top and bottom door sheves can be removed by pulling them in the direction of the arrows, then refitting them in position.
t Periodic cleaning Never use metal objects for clearing your appliance as it may get damaged. Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly. To guarantee a safe operation of the fridge, once a year remove the ventilation grille at the base and clean the air channels with a vacuum cleaner.
TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. INSTALLATION lf this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. This appliance complies with the following E.E.C. Directives: - 73/23 EEC of 19.2.
t Instructions for totally built-in appliances Dimensions of the recess Height of housing Depth of housing Width of housing A mm 880 mm 550 mm 560 50 540 0 56 55 0 880 D022 3. Slide the appliance into the recess, pushing it against the wall on the handle side. PR 32 50 mm min. 200 cm 2 1. It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 540 mm D C D727 min. 200 cm 4.
8mm B A C A D PR266 PR167 6. Separate parts A, B, C, D as shown in the figure. B 50mm 9. Open the appliance door and the furniture door at 90°. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with Ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. A 20m m PR166 7.
