JKE 3034 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS 2222 086-34
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
¥ There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instructions. ¥ Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. ¥ If the appliance has been transported horizontally, it is possible that the oil contained in the compressor ’lows in the refrigerant circuit.
USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish.
MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: Periodic cleaning remove the plug from the wall socket; Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly. remove all food; Interior light defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells.
INSTALLATION Location This appliance complies with the following E.E.C. Directives: The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. - 87/308 EEC of 2/6/87 relative to radio interference suppression. Electrical connection - 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
Remove the upper right screw and pivot. Straighten the safety washer (4) of the lower right hinge. Remove the screw (5) and the pivot (6) (Fig. 3). For safety rea-sons bend the washer located under the left hinge, by using a tool (for ex. a screwdriver). Remove the right door stop hinge (3). 6 4 5 Building-in instructions 50 mm min. 200 cm 2 D563 Dimensions of housing Height 880 mm Depth 550 mm Width 560 mm min. cm 200 For safety reasons, minimum ventilation must be as shown in Fig.
