JGI 3403 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION D t 2222738-55
t Contents Instructions for the user Important Safety Instructions 14 Use 16 Cleaning the interior Control panel Starting-up and temperature regulation NORMAL-SUPER switch Warning light Quick freezing Freezing fresh foods and storage of commercially frozen food Ice-cube trays Thawing Defrosting 16 16 16 16 16 17 Maintenance 18 Periodic clearing Periodic of non-operation 18 18 Customer service and spare parts 19 Instructions for the installer 17 17 17 18 13 Technical specifications 19 Insta
Important Safety Instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
t Installation ■ ■ Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction.
Use The freezer is marked with the symbol, which means that the compartment is suitable for freezing fresie food and long-term storage of frozen food. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish.
t Quick freezing Slide switch (F) towards the right to position «S» («SUPER»). Indicator light (E) will then light up.
Defrosting Frost should be removed from the inside of the compartment with the special plastic scraper provided, whenever the thickness exceeds 4 mm. Do not use metal tools to remove frost so as to avoid seriously damaging the appliance. If a thick layer of ice is formed it will be necessary to carry out complete defrosting as following: 1. unplug the appliance from the mains socket or set knob (B) to position «O». 2.
Customer service and spare parts If the appliance is not functioning properly, check that: the plug is firmly in the wall socket and the mains power switch is on; t If your appliance is still not working properly after making the above checks, contact the nearest service centre.
Door reversibility The appliance door is secured by means of pins for transport. Unscrew pins (A) and (B) from the side on which the door is to open. A B D163 Instructions for totally built-in appliances Dimensions of housing Height 600 mm Depth 550 mm Width 560 mm For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction.
2. Push the appliance up against the side opposite the door hinge. Fix the appliance with the 4 screws supplied. Fit the hinge cover (D), clipping it into place. D D648 3. Press on the seal between the appliance and the kitchen unit. D466 4. Apply covers (B) on joint cover lugs and into hinge holes. 5. Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in the figure and mark the position of the external holes.
6. Open both the appliance door and that of the kitchen unit to approx. 90°. Place the little platee over the runners. Hold the doors of the appliance and the unit together and mark the holes. 8mm PR34 7. Remove the little plates and make the holes with a diam. of 2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes.
