JGI 3403 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION D t 2222738-56
CONTENTS Instructions for the user Important Safety Instructions 13 Use 15 Cleaning the interior Control panel Starting-up and temperature regulation NORMAL-SUPER switch Warning light Quick freezing Freezing fresh foods and storage of commercially frozen food Ice-cube trays Thawing Defrosting 15 15 15 15 15 16 Maintenance 17 Periodic clearing Periodic of non-operation 17 17 Customer service and spare parts 18 Instructions for the installer 16 16 16 17 12 Technical specifications 18 Installa
IMPORTANT SAFETY INSTRUCTIONS t It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety.
Installation ■ ■ Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction.
t USE The freezer is marked with the symbol, which means that the compartment is suitable for freezing fresie food and long-term storage of frozen food. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish.
Quick freezing Slide switch (F) towards the right to position «S» («SUPER»). Indicator light (E) will then light up.
t Defrosting Frost should be removed from the inside of the compartment with the special plastic scraper provided, whenever the thickness exceeds 4 mm. Do not use metal tools to remove frost so as to avoid seriously damaging the appliance. If a thick layer of ice is formed it will be necessary to carry out complete defrosting as following: 1. unplug the appliance from the mains socket or set knob (B) to position «O». 2.
CUSTOMER SERVICE AND SPARE PARTS If the appliance is not functioning properly, check that: the plug is firmly in the wall socket and the mains power switch is on; If your appliance is still not working properly after making the above checks, contact the nearest service centre.
t Door reversibility 50 A in 560 m m 550 540 H 50 H1 in H1 50 H B 50 D163 54 0 Air entry min 200 cm 2 20 The appliance door is secured by means of pins for transport. Unscrew pins (A) and (B) from the side on which the door is to open. D464 2.
50mm A 20m m D466 PR166 8. Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 5. Press on the seal between the appliance and the kitchen unit. A C B PR33/2 9. Fix cover (C) on guide (A) until it clips into place. D013 6. Apply covers (B) on joint cover lugs and into hinge holes. 8mm B A A PR167 C B 10.
t PR168 11. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. B D PR167/1 12. Fix cover (D) on guide (B) until it clips into place.
