User manual

9
In die Befestigungs- und Scharnierlšcher
beiliegende Abdeckkappen (B) eindrŸcken.
Fugenabdeckprofil oben um die Winkeldicke
ausschneiden und zwischen GerŠt und
Mšbelseitenwand eindrŸcken.
D726
B
D724
Die Schiene (A) auf der Innenseite der MšbeltŸr
oben und unten auflegen (siehe Abb.) und die
Position der Šu§eren Bohrlšcher anzeichnen.
Nachdem die Lšcher gebohrt wurden, die Schiene
mit den mitgelieferten Schrauben befestigen.
20mm
A
50mm
PR166
PR33
C
A
PR266
A
B
C
D
Die Teile A, B, C, D abnehmen, wie in der Abb.
gezeigt wird.
Die Abdeckung (C) in die Schiene (A) eindrŸcken,
bis sie einrastet.
12
CONTENTS
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Use - Cleaning the interior - Control Panel - Operation - Temperature regulation - Quick-freezing - Warning .
light - Freezing fresh food - Storage of frozen food . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
Use - Thawing - Ice-cube production - Hints - Hints for freezing - Hints for storage of frozen food . . . . . . . .14
Maintenance - Periods of no operation - Periodic cleaning - Defrosting . . . . . . . . . . . . . . . . . . . . . . . . . . .15
Customer service and spare parts - Installation - Location - Electrical connection - Door reversibility . .
Building-in instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
¥ There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
¥ Parts which heat up should not be exposed.
Wherever possible the back of the product
should be against a wall.
¥ If the appliance has been transported
horizontally, it is possible that the oil contained in
the compressor ’lows in the refrigerant circuit. It
is advisable to wait at least two hours before
connecting the appliance to allow tlõe oil to flow
back in the compressor.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol are recyclable.