JDZ 7051 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS 2222 350-33
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
¥ Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation ¥ During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the relevant Figure. Attention: keep ventilation openings clear of obstruction.
USE Cleaning the interior Fresh food refrigeration Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. To obtain the best performance: Do not use detergents or abrasive powders, as these will damage the finish.
Thawing Ice-cube production Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer.
HINTS Hints for refrigeration ¥ wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; ¥ do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; For safety, store in this way only one or two days at the most. ¥ lean foods store better and longer than fatty ones; salt reduces the storage life of food; Cooked foods, cold dishes, etc..: these should be covered and may be placed on any shelf.
Interior light The light bulb inside the refrigerator compartment can be reached as follows: - unscrew the light cover securing screw. - unhook the moving part as shown in the figure. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover.
CUSTOMER SERVICE AND SPARE PARTS opening is not obstructed (see ÒDefrostingÓ section). If the appliance is not functioning properly, check that: ¥ the plug is firmly in the wall socket and the mains power switch is on; ¥ there is an electricity supply (find out by plugging in another appliance); ¥ the thermostat knob is in the correct position.
Right opening Left opening Remove the pins (P) and (P1) Remove (P) from both sides and the door. Remove the middle hinge (A) and refit it on the opposite side. Refit the door and (P) on the left side. Remove (P1) from the right side. Inner door reversal 1) Using a screwdriver release bracket (1) by pressing on the internal spring (Fig.
A Slide the appliance into the recess, pushing it against the wall on the handle side. D023 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position.
50mm Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. A 20m m PR166 Fix cover (C) on guide (A) until it clips into place. A C PR33 Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure.
