Montage- und Gebrauchsanweisung für den Dunstabzug Instruction on mounting and use of the cooker hood JDK 8460 1
O 1 2 3 F C O I 1 3 2 K 2 3 Abb. 2 Fig. 2 Abb. 1 Fig. 1 B Abb. 4 Fig. 4 Abb. 3 Fig. 3 I I Abb. 5 Fig.
Abb. 6 Fig.
— No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. — Please, keep to the provisions of official directives regarding the question of fume discharge.
Mounting the hood - Fig. 6 Operation a. Put the template onto the wall (1) and drill two Ø12mm (2) and two Ø 8 mm (3) holes. b. Fit two hooks (4) on the drilled Ø 12mm holes. c. Fit two Ø 8mm wall dowels (5) on the upper holes. d. Remove the metal filters e. Hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (6). f. Fix the hood definitively with two washers (7) and two screws 5x45 mm (8). The hood has one variable speed motor.
Filter saturation control devices for grease filters Reset for the saturation control devices for grease and carbon filters This hood is supplied with a device that notifies the user when the grease filter must be cleaned or the carbon filter replaced (if installed). Upon installation, the saturation control device for the carbon filter is not activated (the hood is ready for use in vent mode).
Replacing the lamp - Fig. 4 a) Disconnect the hood from the electricity. b) Remove the blown halogen light bulb using a screwdriver. c) Only ever use halogen light bulbs with a maximum of 20 W. d) Fit the new light bulb taking care to ensure its contacts are correctly fitted in the connector.
ELECTROLUX HAUSGERÄTE GMBH Rennbahnstraße 72-74 60528 Frankfurt L 850 Ed.
