Montagevorschrift und Gebrauchsanleitung für den Dunstabzug Instructions on mounting and use of the cooker hood JDK 7940
1 2 c b d a 3 Abb. 1 Fig. 1 Abb. 2 Fig. 2 Abb. 3 Fig. 3 Abb. 4 Fig. 4 Abb. 5 Fig.
c b a Abb. 6 Fig. 6 Abb. 7 Fig. 7 Abb. 8 Fig.
GB View of the hood Warning! 1. Control panel 2. Operating light 3. Grease filters — The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. — When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. — No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires.
GB The power plug must be disconnected from the mains during the mounting procedure. to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user’s failure to observe the above instructions. Exhausting version l. Fit a Ø 150 mm exhausting pipe or flex tube on the hood outlet on top of the motor housing and connect it to the wall or roof outlet pipe. Mounting of hood a.
GB Using the hood The hood has one variable speed motor. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. O A A B E F C D G H I - 1 B E 2 3 F C F C D G O I H I Motor OFF button ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 - . . . .
GB N.B.: the carbon filter saturation led will also flash even if the hood is used in the exhausting version (i.e. without carbon filter). To stop the led flashing, press the two buttons as described above. Changing the lighting elements a. With the help of a screwdriver remove the screw that secures the lamp cover (Fig. 8). b. Remove the lamp cover. c. Replace the damaged part with one of equal rating (PL 11Watt max.). d. Mount the lamp cover and secure it with the screw.
ELECTROLUX - ZANUSSI HAUSGERÄTE GMBH Rennbahnstraße 72-74 D-60528 Frankfurt LI08HA
