Montage- und Gebrauchsanweisung für den Dunstabzug Instruction on mounting and use of the cooker hood JDA 5130 JDA 5230
3 0 2 I 01 23 4 5 1 5 A B Fig. 2 Fig. 1 Fig.
C C C C DD D D E P 280 L S C Fig. 4 500 10÷50 58A H H L G G Fig. 5 Fig.
M Fig.
View of the hood Installation 1) 2) 3) 4) 5) When installed, the hood must be not less than 65 cm. above electric burners or 75 cm. above gas or mixed-fuel burners. Motor speed switch Light switch Extractable drawer Grid Cooking surface lighting Warning! — The hood cannot be connected to flues of other appliances that run on energy sources other than electricity.
Electric connection Only for JDA 5230 Replacing the plastic front Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. The hood is supplied with a standard plug; connect it to a correspondingly standard socket.
Maintenance Replacing the lamp Before performing any maintenance operation, disconnect the hood from the electricity. a. b. c. d. Disconnect the hood from the electricity. Pull-out the extractable drawer. Remove the inlet grid. Always replace burnout bulbs with oliveshaped max 40 Watt (E14) bulbs. e. Refit the inlet grid. — Before calling for Repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. Metal grease filter The hood has a metal grease filter.
ELECTROLUX - ZANUSSI HAUSGERÄTE GMBH Rennbahnstraße 72-74 D-60528 Frankfurt LI08LA
