User manual

Setting and changing the time
After the first connection to the mains, wait
until the display shows and 12:00. "12"
flashes.
1. Press or to set the hours.
2. Press .
3. Press or to set the minutes.
4. Press .
The display shows the new time.
To change the time of day press
again
and again until starts to flash.
Setting the Duration
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press or to set the minutes for
Duration.
4. Press or the Duration starts
automatically after 5 seconds.
5. Press
or to set the hours for
Duration.
6. Press
or the Duration starts
automatically after 5 seconds.
When the set time ends, the signal sounds
for 2 minutes. The display shows flashing
and time setting. The oven turns off.
7. Press a sensor field to stop the signal.
8. Turn off the oven.
Setting the End Time
1. Set a heating function and
temperature.
2. Press
again and again until
starts to flash.
3. Press or to set the End Time
and press . First you set the
minutes and then the hours.
When the set time ends, the signal sounds
for 2 minutes. The display shows flashing
and the time setting . The oven turns
off automatically.
4. Press a sensor field to stop the signal.
5. Turn off the oven.
Setting: Time Delay
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press or to setthe minutes for
Duration.
4. Press .
5. Press or to set the hours for
Duration.
6. Press .
The display shows flashing .
7. Press or to set the End Time
and press . First you set the
minutes and then the hours.
The oven turns on automatically later on,
works for the set Durationand stops at the
set End Time. When the set time ends, the
signal sounds for 2 minutes. The display
shows flashing
and the time setting .
The oven turns off automatically.
8. Press a sensor field to stop the signal.
9. Turn off the oven.
When the Time Delay function
is turned on, the display shows
a symbol of the heating
function, with a dot and .
The dot shows which clock
function is on in the Clock /
residual heat display.
Setting: Set + Go
You can use the Set + Go function only
when the Duration is set.
1. Set a heating function and
temperature.
2. Set the Duration.
3. Press
again and again until the
display shows flashing .
4. Press to set the Set + Go function.
The display shows and with an
indicator. This indicator shows which clock
function is activated.
14