Installation Guide

INSTALLATION INSTRUCTIONS
Juno Smart LED RGBW Speaker LED Trim Kit
PAGE | 4
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Juno Retrofit LED Trim Compatibility in Recessed Cans
Juno Retrofit LED trims are designed to work with most standard UL listed
recessed incandescent housings. When used with standard medium base
incandescent housings, the medium base socket adaptor must be used. Housing
compatibility can be determined by measuring the recessed housing diameter and
height as shown in the diagram. Refer to the chart for compatible size ranges.
Housing construction features vary. The height and diameter chart should be used
as a guideline. Actual installation is the best method of determining compatibility.
J6SLC 5/6"
Internal Diameter
6" min
Internal Height
5.75" min
Trim Flange Diameter
7.67"
INSTALLATION STEPS:
Step 1: PREPARE FOR FIXTURE INSTALLATION
1.1 Ensure input power is 120V, 60Hz, supply wires are rated for at least 90°C (194°F), and power is
disconnected by turning OFF the circuit breaker or by removing the appropriate fuse at the fuse box.
1.2 If necessary, remove old ballast.
1.3 Read the entirety of the installation instructions manual prior to installation.
Step 2: DETERMINE WIRING METHOD (SELECT ONE WIRING METHOD)
A. E26 Socket Adapter:
1. Screw adapter into the base socket inside housing. (Figure 1)
2. Plug orange connector of adapter into the fixture’s mating orange connector.
Figure 1
912-00386-001 REV B
DATE 05/2023
One Lithonia Way · Conyers, GA 30012 · Phone [phone]
Visit us at www.acuitybrands.com/juno-recessed
© 2023 Acuity Brands Lighting, Inc.