Specification

1300 South Wolf Road, Des Plaines, IL 60018 | 847 827 9880 | www.acuitybrands.com
© 2018 Acuity Brands Lighting, Inc. All rights reserved. Rev. 05/08/18 Page 2 of 2
CONTRACTOR SELECT IC1 LEDT24/IC1R LEDT24
IC1 LEDT24
IC1R LEDT24
ELECTRONIC CONNECTIONS:
Features non-screw base 120V plug-in connector • Compatible with Juno retrot LED trim
modules.
LABELS:
U.L. listed for U.S. and Canada for through-branch wiring and damp locations • Meets high
efcacy requirements of California T24.
TESTING:
All reports are based on published industry procedures; eld performance may differ from
laboratory performance.
REAL NAIL® BAR HANGERS (NEW CONSTRUCTION HOUSINGS ONLY):
Telescoping, Real Nail® 3 system covered under US Patent D552,969 permits quick
placement of housing anywhere within 24” O.C. joists or suspended ceilings • Integral T-bar
notch and clip secures housing in suspended ceiling grid – no accessory clips required • 24”
expansion stop allows quick placement of xture in standard grid spacing • Bars scored in
two locations for fast, clean breaking, allowing housing installation in tight applications
• Bars captive to mounting frame • Edgemounted for extra strength • Captive bugle-headed
ring shank nail for quick one-step installation and easy removal with claw hammer for xture
relocation • Quick-Loc slot and oversized locking set screw lock xture in position • Bar
hanger foot contoured to align to bottom of construction joist • Alternate mounting holes
included.
JUNCTION BOX:
Pre-wired junction box provided with (6) ½” ((5) 1/2" for remodel version) and (1) ¾”
knockouts (IC1 only, not remodel), (4) Non-metallic sheathed cable connectors and ground
wire, U.L. listed/CSA certied for through-branch wiring, maximum 4 No. 12 AWG 90˚ C
branch circuit conductors (2 in, 2 out) • Junction box provided with removable access plates
• Knockouts equipped with pryout slots.
MOUNTING FRAME (NEW CONSTRUCTION HOUSINGS ONLY):
22-gauge die-formed galvanized steel mounting frame • 9 1/8” L x 6 3/4” W, (excluding bar
hangers) • Rough-in section (junction box, mounting frame, housing and bar hangers) fully
assembled for ease of installation.
IC1 HOUSING:
Air-Loc IC housing, .032” aluminum • Inner housing is vertically adjustable to accommodate
up to a 1¼” ceiling thickness.
IC1R HOUSING:
IC aluminum housing sealed for Air-Loc Compliance • Remodel springs accommodate up to
a 5/8” ceiling thickness.
WARRANTY:
1-year limited warranty. Complete warranty terms located at:
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Note: Actual performance may differ as a result of end-user environment and application.
All values are design or typical values, measured under laboratory conditions at 25 °C.
Specications subject to change without notice.
Specifications Dimensions
13 1/2"
Will expand
to 25"
(Reduces to 8 1/2"
with breakaway
feature)
12 1/4"
6"
6 3/4"
9 1/8"
4 1/2" CEILING CUTOUT
12"
5 1/2"
4 3/8" CEILING CUTOUT
4 1/4"