Specification Sheet

One Lithonia Way • Conyers, GA 30012 • Phone 1-800-705-SERV (7378) • Visit us at www.acuitybrands.com

1 of 3

Project:

Fixture Type:

Location:

Contact/Phone:

PRODUCT DESCRIPTION

These low voltage fixtures offer both mechanical and electrical compatibility with most MR16 LED lamps (by others). Constructed with open or

semi-open designs, this series provides for improved airflow around the lamp, leading to better cooling and optimized LED lamp life. They may

also be used with MR16 halogen lamps with integral cover glass. The horizontal version has an integral transformer housing which is centered

above the lampholder, offering a new and unique aesthetic in a small, close-to-the-trac fixture footprint.

PRODUCT SPECIFICATIONS

Construction Lampholders are constructed of die cast aluminum • Transformer housings are constructed of molded polycarbonate.

Socket GU5.3/GX5.3 ceramic bi-pin.

Lamp Compatible with most 12VAC MR16 LED lamps (by others) – contact lamp manufacturer to confirm transformer compatibility • Also

compatible with 50W max. 12VAC MR16 halogen lamps with integral cover glass.

Transformer Hatch RL12-60M-LED, 60VA, 12VAC solid state electronic • Integral to fixture in either horizontal or vertical orientation • ANSI/

IEEE C62.41.Class A transient protection • Short circuit protection.

Dimming Dimmable (with dimmable lamps) using Acuity nLight wired dimming controls, including Fresco controllers, when combined with an

nLight nSP5 PCD ELV 120 Secondary Relay and Dimming Pack (required) at the trac input • Dimming range of 100% down to 1% typical* with a

minimum load of one fixture and maximum load of 475W @ 120VAC • Also dimmable using a variety of standard wall box dimmers – contact

lamp manufacturer to confirm compatibility.

Juno Universal Trac Adapter Universally compatible with both Trac-Master 1-circuit or 2-circuit trac, Trac-Lites trac, monopoints and special

mountings • Also UL Recognized for use on ConTech® LT Series track • Copper alloy contacts provide precise spring action - no arcing and will not

take a set • True, positive electrical ground • Spring-loaded positive latch with embossed polarity arrows secures trac light to trac • Two-position

power contact provided for two-circuit application.

Alternate GTYPE Trac Adapter Compatible with track systems based on GES type track, including Lithonia LT Commercial Track (not LTS type)

• System specific and assembled to trac fixture • Consult factory for additional information.

Alternate HTYPE Trac Adapter Compatible with track systems which use a H-type track adapter, including Lithonia LTS Decorative Track (not

LT type) • System specific and assembled to trac fixture • Two-position power contact provided for two-circuit application • Consult factory for

additional information.

Alternate LTYPE Trac Adapter Compatible with track systems which use a L-type track adapter • System specific and assembled to trac fixture

• Two-position power contact provided for two-circuit application • Consult factory for additional information.

Accessories T1042 can accommodate up to two accessories using Accessory Spring Kit.

Aiming 90° vertical aiming capability and 358° rotation.

Labels UL and C-UL Listed • Fixtures can be assembled with reduced maximum wattage rating labels to facilitate energy code compliance –

consult factory • Union made • Assembled in U.S.A.

Specifications subject to change without notice.

*Typical dimming range based on laboratory evaluation – actual installation conditions and results may vary.

D1.4.6

TRAC-MASTER

Low Voltage

MR16 LED-COMPATIBLE

LAMPHOLDERS

T1040, T1041, T1042 and T1043

ConTech is a registered trademark of ConTech Lighting.