Specification Sheet

One Lithonia Way • Conyers, GA 30012 • Phone [phone]-SERV (7378) • Visit us at www.acuitybrands.com
Printed in U.S.A. ©2017-2020 Acuity Brands Lighting, Inc. Rev. 12/16/20
3 of 6
D1.1.0
TRAC-MASTER
®
One Circuit Trac System
TRAC SECTION, JOINERS & FEEDS
T Series
Trac Joiners & Dead End
Examples: T20 BL, T25 RP WH
T20 T23 T24N
‡ T24F ‡
BL, SL, WH BL, SL, WH BL, SL, WH BL, SL, WH
Accordion Adjustable
Joiner
Miniature Straight
Connector
Adjustable Connector Adjustable Connector
Can flex to 90° angle to left, right, up or
down. Joins two trac sections.
Joins two trac sections end to end. Joins two trac sections to make a 90
˚
angle or straight run. Straight and right
angle covers supplied. For outlet box feed,
No. T27 cover plate required.
Same as T24 but with integral
ground connection. For outlet box
feed, No. T27 cover plate required.
T25 ‡ T25 RP ‡ T25 F ‡ T26 ‡ T26 F ‡
BL, SL, WH BL, SL, WH BL, SL, WH BL, SL, WH BL, SL, WH
“T” Connector “T” Connector “T” Connector “X” Connector “X” Connector
Joins three trac sections. For outlet
box feed, No. T27 cover plate required.
Same as T25 except designed for
use in opposite polarity orientation
compared to standard feed connectors.
Same as T25 but with integral ground
connection. For outlet box feed, No. T27
cover plate required.
Joins four trac sections at 90
˚ angles.
For outlet box feed, T27 cover plate
required.
Same as T26 but with integral ground
connection. For outlet box feed, No.
T27 cover plate required.
T27 T28 T35 T49
BL, SL, WH BL, SL, WH BL, SL, WH BL, SL, WH
Outlet Box Cover Trac Dead End
T-Bar Adjustable Joiner
Feed
Trac Continuation Kit
Use with Nos. T24/T25/T26 for
outlet box electrical feed. Includes:
nipple, locknut and ground screw.
For use with field-cut trac sections. Joins two trac sections to make 90°
angle or straight run. Wiring compartment
contains standard 1/2” KO’s. Feeds from
above when T-bar is directly above trac.
Permits trac to continue a run around
obstructions. Includes one T34 Conduit
Feed and one T34 RP Conduit Feed.
Fits standard 1/2” conduit.
‡ T24N, T25 and T26 may not be used as feed
connectors in Canada due to special grounding
requirements – T24F, T25F & T26F are approved
for use as feed connectors in Canada (may also
be used in U.S.).
1 3/8"
2 3/4"
4 1/8"