Installation Manual
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions.
2. Do not install this trac in damp or wet locations.
3. Do not install any part of Trac System less than 5’ above floor.
4. Do not install any fixture assembly closer than 6 inches from any curtain or similar combustible material.
5. Disconnect electrical power before adding to or changing the configuration of the trac.
6. Do not attempt to energize anything other than lighting fixtures on the trac. To reduce the risk of fire or electrical shock, do not attempt to
connect power tools, extension cords, convenience receptacle adapters, appliances or the like to the trac.
7. Trac is not intended to be connected with power cord or to more than one branch circuit. If improperly wired, the trac system may
appear to operate acceptably, but an electric shock hazard may result. Check with a qualified electrician before wiring trac.
Installation Instructions
For Juno R Series Trac Sections
Read all of these installation instructions before installing the trac system. Save these instructions and refer to them when additions to or
changes in the trac configuration are made. Use only fixtures intended for use with Juno “R”, “T”, “TU” and “TT” Series trac systems. Use only
fittings intended for Juno “R” Series Trac.
Polarity Line
Polarity Arrows
Polarity
Arrow
Trac-Lites
TM
Existing
Junction Box
(not Included)
Screws
J-Box Mounting
Strap
Ground
Screws
Locknut
Cover
Terminal
Screws
Set
Screw
Polarity
LIne
Polarity
Arrow
Feed
Connector
R21 End Feed
Polarity
All trac components are mechanically and visually polarized to assure
proper connections and grounding.
NOTE:
1. Trac face has polarity line indicating positive side.
2. Trac connectors have arrow which must point towards polarity line on
trac section.
3. Trac fixture adapter has arrows which must point toward the polarity
line on trac system.
4. Make sure power is OFF before wiring.
INSTALLATION for Electrical feed at outlet box.
Use No. 12 AWG solid copper wire only. Rated 120V, 60Hz, 20A.
For standard ceiling using R21 End Feed:
1. Make sure that power is OFF.
2. Pull junction box wires through mounting strap hole. Attach mounting
strap to existing junction box with enclosed screws.
3. Insert feed connector fully into Trac with arrow pointing toward Trac
polarity line and secure with set screw.
4. Attach Trac to ceiling (or wall) following instructions supplied with the
Trac section.
5. Pull junction box wires through feed connector and nipple.
6. Secure feed connector to mounting strap with lock nut and nipple
provided.
7. Fasten positive wire to screw terminal marked “P”.
8. Fasten white wire (neutral) to screw terminal marked “N”.
9. Connect ground wire to ground screw.
10. Replace cover and secure with screw.
11. Attach trac to ceiling with toggle bolts or screws.
For T-Bar or Drop Tile
1. Make sure power is OFF.
2. Follow electrical feed installation instructions for R36 T-Bar End Feed.
3. Attach trac to ceiling with R37F T-Bar Clips or R37D Drop Ceiling Clips.
Maximum distance between clips is 4’.
(Continued on back)