Datasheet

•
Configurable WAN-PHY mode options:
•
loopback
•
mpls
•
path-trace
•
trigger
•
Optical diagnostics, monitoring, and alarms
•
Flexible Ethernet Services Encapsulation
•
802.1q virtual LANs (VLANs)
•
Ethernet OAM 802.1ag continuity check
•
Ethernet OAM 802.3ah (remote loopback is not supported for this PIC)
•
VLAN stacking
•
Channels defined by two stacked VLAN tags
•
Multiple tag protocol identifiers (TPID) support
•
IP service for nonstandard TPID and stacked VLAN tags
•
MAC learning, accounting, and filtering
•
Virtual Router Redundancy Protocol (VRRP) support
Software features
•
You can install any transceiver supported by the PIC.
•
Connector: Duplex LC (Rx and Tx)
•
Fiber-optic 10-Gigabit small form-factor pluggable (XFP) transceivers:
•
10GBASE-S (model number: XFP-10G-S)
•
10GBASE-L (model number: XFP-10G-L-OC192-SR1)
•
10GBASE-E (model number: XFP-10G-E-OC192-IR2)
•
10GBASE-Z (model number: XFP-10G-Z-OC192-LR2)
•
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
•
DWDM Tunable XFP transceivers:
•
10GBASE-ZR (model number: XFP-10G-CBAND-T50-ZR)
•
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
•
DWDM supported wavelengths—see 10-Gigabit Ethernet DWDM Transceiver Wavelengths
Cables and connectors
Port LED, labeled PORT 0 through PORT 3, one for each port:
•
Off—Port is not enabled.
•
Green—Port is online with no alarms or failures.
•
Yellow—Port is online with alarms for remote failures.
•
Red—The router has detected a failure with alarms for local failures.
LEDs
87Copyright © 2013, Juniper Networks, Inc.
10-Gigabit Ethernet LAN/WAN PIC with XFP (T4000 Router)