Datasheet

You can install any transceiver supported by the PIC.
•
Duplex LC/PC connector (Rx and Tx)
•
Fiber-optic 10-Gigabit small form-factor pluggable (SFP+) transceivers.
Type 4 PIC:
•
10GBASE-ER (model number: SFPP-10GE-ER)
•
10GBASE-LR (model number: SFPP-10GE-LR)
•
10GBASE-SR (model number: SFPP-10GE-SR)
•
10BASE-ZR (model number: SFPP-10GE-ZR) Junos OS Release 12.3 and later
Type 5 PIC:
•
10GBASE-SR (model number: SFPP-10GE-SR)
•
10GBASE-LR (model number: SFPP-10GE-LR)
•
10GBASE-ER (model number: SFPP-10GE-ER) Junos OS Release 12.1R2 and later
•
10BASE-ZR (model number: SFPP-10GE-ZR) Junos OS Release 12.3 and later
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
Cables and connectors
PIC STATUS LED, one tricolor:
•
Off—PIC is offline and safe to remove from the router.
•
Green—PIC is operating normally.
•
Yellow—PIC is initializing.
•
Red—PIC has an error or failure.
Port LEDs, one pair for each port. The ports on the Type 4 PIC are labeled PORT 0 through PORT
9. The ports on the Type 5 PIC are labeled 0 through 23.
•
Link status LED. The LEDs on the Type 4 PIC are labeled LINK. The Type 5 PIC has no labels
for the link status LED.
•
Green—Port is online with no alarms or failures.
•
Red—The router has detected a failure with alarms.
•
Off—Port is not enabled.
•
Link activity LED. The LED on the type 4 PIC is labeled ACT. The type 5 PIC has no label for the
link activity LED.
•
Green flashing—Port is sending or receiving packets.
•
Off—No packet activity detected on the port.
LEDs
Copyright © 2013, Juniper Networks, Inc.84
T4000 Core Router Interface Module Reference