Datasheet

•
Two modes of operation: 12 ports in line-rate mode, 24 ports in oversubscribed mode
•
Intelligent handling of oversubscribed traffic
•
LAN-PHY mode or WAN-PHY mode selectable per port
•
IEEE 802.3ad Link Aggregation (on single chassis)
NOTE: For PICs that support oversubscription, the PIC must be in line-rate mode to support
aggregated Ethernet.
•
Interface hold timer
•
SNMP support to access all 10 Gigabit Ethernet port counters
•
Graceful Routing Engine switchover (GRES)
•
L2 Protocol support:
•
Ethernet CCC, Ethernet TCC, Ethernet VPLS
•
VLAN CCC
•
Extended VLAN TCC
•
VLAN VPLS
•
Flexible-Ethernet-services
•
L3 Protocol support
•
IPv4
•
IPv6
•
MPLS
•
MAC filtering, accounting, policing, and learning for source media access control (MAC) on
logical interfaces
•
Flexible encapsulation
•
Single, stacked, and flexible VLAN tagging modes
•
Native VLAN configuration to allow untagged frames to be received on the tagged interfaces
•
IEEE 802.3ad Link Aggregation (on single chassis)
NOTE: For PICS that support oversubscription, the PIC must be in line-rate mode to support
aggregated Ethernet.
•
Defining the VLAN rewrite operation to be applied to the incoming and outgoing frames on
logical interfaces on this PIC.
NOTE: Only the Tag Protocol Identifier (TPID) 0x8100 is supported.
•
Interoperability with other 10-Gigabit Ethernet PICs on M Series and T Series routers in LAN
PHY and WAN PHY mode.
•
Behavior aggregate (BA) classification (IPv4 DSCP, IPv6 DSCP, Inet precedence, IEEE 802.1P,
IEEE 802.1AD, MPLS EXP) and fixed classification.
Software features for
Type 5 PIC
83Copyright © 2013, Juniper Networks, Inc.
10-Gigabit Ethernet LAN/WAN PIC with Oversubscription and SFP+ (T4000 Router)