Datasheet

Ten Gigabit Ethernet ports
Power requirement: 0.62 A @ 48 V (29.9 W)
Supports large Ethernet frame sizes for more efficient throughput across the intra-POP network
Model number for 2-port Gigabit Ethernet PIC: PB-2GE-SFP
Model number for 4-port Gigabit Ethernet PIC: PB-4GE-SFP
Model number for 10-port Gigabit Ethernet PIC: PC-10GE-SFP
High-performance throughput on each port at speeds up to 1 Gbps
Autonegotiation between Gigabit Ethernet circuit partners
Full-duplex mode
Maximum transmission units (MTUs) of up to 9192 bytes
Hardware features
Virtual Router Redundancy Protocol (VRRP) support
802.1q virtual LANs (VLANs) support
960 destination MAC filters per port
Optical diagnostics and related alarms
Passive monitoring for IPv4 packets
NOTE: The 10-port Gigabit Ethernet PIC with SFP does not support MAC accounting and policing,
MAC learning, TPID, or flexible Ethernet encapsulation.
The 10-port Gigabit Ethernet PIC supports 64 source MAC filters per port.
Software features
You can install any transceiver supported by the PIC.
Fiber-optic SFP transceivers:
Duplex LC connector (Rx and Tx)
1000BASE-LH (model number: SFP-1GE-LH)
1000BASE-LX (model number: SFP-1GE-LX)
1000BASE-SX (model number: SFP-1GE-SX)
Optical interface specifications—see Gigabit Ethernet 1000BASE Optical Interface
Specifications
1000BASE-BX (model number pairs: SFP-GE10KT13R14 with SFP-GE10KT14R13,
SFP-GE10KT13R15 with SFP-GE10KT15R13, SFP-GE40KT13R15 with SFP-GE40KT15R13)—See
Fast Ethernet and Gigabit Ethernet Bidirectional SFP Optical Interface Specifications
Copper transceiver:
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
1000BASE-T (model number: SFP-1GE-T)
Pinout: MDI crossover
Copper interface specifications—see Gigabit Ethernet 1000BASE-T Copper Interface
Specifications
NOTE: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize
the SFP.
Cables and connectors
57Copyright © 2013, Juniper Networks, Inc.
Gigabit Ethernet PICs with SFP (T4000 Router)