Datasheet

•
You can install any transceiver supported by the PIC.
•
Fiber-optic SFP transceivers:
•
Duplex LC/PC connector (Rx and Tx)
•
1000BASE-LH (model number: SFP-1GE-LH)
•
1000BASE-LX (model number: SFP-1GE-LX)
•
1000BASE-SX (model number: SFP-1GE-SX)
•
Optical interface specifications—see Gigabit Ethernet 1000BASE Optical Interface
Specifications
•
1000BASE-BX (model number pairs: SFP-GE10KT13R14 with SFP-GE10KT14R13,
SFP-GE10KT13R15 with SFP-GE10KT15R13, SFP-GE40KT13R15 with SFP-GE40KT15R13)—See
Fast Ethernet and Gigabit Ethernet Bidirectional SFP Optical Interface Specifications
•
Copper transceiver:
•
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
•
1000BASE-T (model number: SFP-1GE-T)
•
Pinout: MDI crossover
•
Copper interface specifications—see Gigabit Ethernet 1000BASE-T Copper Interface
Specifications
NOTE: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize
the SFP.
Cables and connectors
Status LED, one bicolor:
•
Off—PIC is not enabled.
•
Green—PIC is operating normally.
•
Red—PIC has an error or failure.
Port LEDs, one pair per port:
•
Link—If green, the port is online; if there is no light, the port is down.
•
Activity—If flashing green, the port is receiving data; if there is no light, the port might be on but
is not receiving data.
LEDs
Related
Documentation
T4000 PIC Description on page 3•
• T4000 PICs Supported on page 4
55Copyright © 2013, Juniper Networks, Inc.
Gigabit Ethernet PICs with SFP (T4000 Router)