User Manual

•
Configurable WAN-PHY mode options
•
See “Protocols and Applications Supported by DPCs and Enhanced DPCs (DPC and DPCE-R)”
on page 49 for information about the protocols and applications that this DPC supports.
Software features
•
You can install any transceiver supported by the DPC. For information about installing and
removing transceivers, see the hardware guide for your router.
•
Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
10GBASE-E (model number: XFP-10G-E-OC192-IR2)
•
10GBASE-L (model number: XFP-10G-L-OC192-SR1)
•
10GBASE-S (model number: XFP-10G-S)
•
10GBASE-Z (model number: XFP-10G-Z-OC192-LR2)
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
•
DWDM Tunable XFP transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
10GBASE-ZR (model number: XFP-10G-CBAND-T50-ZR)
DWDM supported wavelengths—see 10-Gigabit Ethernet DWDM Transceiver Wavelengths
NOTE: XFP-10G-CBAND-T50-ZR is supported in Junos OS Release 10.2 and later
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
Cables and connectors
OK/FAIL LED, one bicolor:
•
Steady green—DPC is functioning normally.
•
Blinking green—DPC is transitioning online or offline.
•
Red—DPC has failed.
TUNNEL LED, one green per port:
•
Off—Normal operating mode.
•
On steadily—Port configured in tunnel mode.
LINK LED, one green per port:
•
Off—No link.
•
On steadily—Link is active.
The TUNNEL and LINK LEDs are labeled top to bottom:
•
2-port: 0/0 through 1/0
•
4-port: 0/0 through 3/0
LEDs
Related
Documentation
MX Series DPC Overview on page 4•
• DPCs Supported on MX240, MX480, and MX960 Routers on page 6
• 10-Gigabit Ethernet 10GBASE Optical Interface Specifications
27Copyright © 2013, Juniper Networks, Inc.
10-Gigabit Ethernet Enhanced DPCs with XFP