User Manual

•
Optical diagnostics and related alarms
•
See “Protocols and Applications Supported by Enhanced Queuing IP Services DPCs (DPCE-R-Q)”
on page 61 for information about the protocols and applications that this DPC supports.
Software features
•
You can install any transceiver supported by the DPC. For information about installing and
removing transceivers, see the hardware guide for your router.
•
Fiber-optic small form-factor pluggable (SFP) transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
1000BASE-EX (model number: SFP-GE40KM)
•
1000BASE-LH (model number: SFP-1GE-LH)
•
1000BASE-LX (model number: SFP-1GE-LX)
•
1000BASE-SX (model number: SFP-1GE-SX)
Optical interface specifications—see Gigabit Ethernet 1000BASE Optical Interface Specifications
•
Copper SFP transceivers:
•
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
•
1000BASE-T (model number: SFP-1GE-T)
•
Pinout: MDI crossover
•
Length: 328 ft/100 m
Copper interface specifications—see Gigabit Ethernet 1000BASE-T Copper Interface
Specifications
•
Bidirectional SFP transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
1000BASE-BX (model number pairs: SFP-GE10KT13R14 with SFP-GE10KT14R13,
SFP-GE10KT13R15 with SFP-GE10KT15R13, SFP-GE40KT13R15 with SFP-GE40KT15R13)
Optical interface specifications—see Fast Ethernet and Gigabit Ethernet Bidirectional SFP
Optical Interface Specifications
NOTE: Do not install Gigabit Ethernet SFPs in the SONET/SDH port. The port will not recognize
the SFP.
Cables and connectors
21Copyright © 2013, Juniper Networks, Inc.
Gigabit Ethernet Enhanced Queuing IP Services DPCs with SFP