User Manual

You can install any transceiver supported by the PIC. For information about installing and removing
transceivers, see the hardware guide for your router.
•
Fiber-optic small form-factor pluggable (SFP) transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
SONET/SDH OC3/STM1 SFPs:
•
Multimode (model number: SFP-OC3-SR)
•
Intermediate reach (IR-1) (model number: SFP-OC3-IR)
•
Long reach (LR-1) (model number: SFP-OC3-LR)
Optical interface specifications—see SONET/SDH OC3/STM1 Optical Interface Specifications
•
SONET/SDH OC12/STM4 SFPs:
•
Short reach (SR-1) (model number: SFP-OC12-SR)
•
Intermediate reach (IR-1) (model number: SFP-OC12-IR)
•
Long reach (LR-1) (model number: SFP-OC12-LR)
Optical interface specifications—see SONET/SDH OC12/STM4 Optical Interface
Specifications
•
SONET/SDH OC48/STM12 SFPs:
•
Short reach (SR-1) (model number: SFP-1OC48-SR)
•
Intermediate reach (IR-1) (model number: SFP-1OC48-IR)
•
Long reach (LR-2) (model number: SFP-1OC48-LR)
Optical interface specifications—see SONET/SDH OC48/STM16 Optical Interface
Specifications
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid links,
take the PIC offline until you are ready to establish a link to another device. For information about
taking a PIC offline, see the request chassis pic offline command in the Junos OS Operational Mode
Commands.
Cables and connectors
One tricolor per port:
•
Off—Not enabled
•
Green—Online with no alarms or failures
•
Yellow—Online with alarms for remote failures
•
Red—Active with a local alarm; router has detected a failure
LEDs
173Copyright © 2013, Juniper Networks, Inc.
SONET/SDH OC12/STM4 (Multi-Rate) PIC with SFP