User Manual

•
Configurable LAN-PHY and WAN-PHY mode options
•
Synchronous Ethernet support
•
Optical diagnostics and related alarms
•
Virtual Router Redundancy Protocol (VRRP) support
•
IEEE 802.1Q virtual LANs (VLANs) support
•
Remote monitoring (RMON) EtherStats
•
Source MAC learning
•
MAC accounting and policing—Dynamic local address learning of source MAC addresses
•
Flexible Ethernet encapsulation
•
Multiple tag protocol identifiers (TPID)
Software features
•
Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
10GBASE-E (model number: XFP-10G-E-OC192-IR2)
•
10GBASE-L (model number: XFP-10G-L-OC192-SR1)
•
10GBASE-S (model number: XFP-10G-S)
•
10GBASE-Z (model number: XFP-10G-Z-OC192-LR2)
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
•
DWDM Tunable XFP transceivers:
•
Connector: Duplex LC/PC (Rx and Tx)
•
10GBASE-ZR (model number: XFP-10G-CBAND-T50-ZR)
DWDM supported wavelengths—see 10-Gigabit Ethernet DWDM Transceiver Wavelengths
NOTE: XFP-10G-CBAND-T50-ZR is supported in Junos 10.2 and later
Optical interface specifications—see 10-Gigabit Ethernet 10GBASE Optical Interface
Specifications
Cables and connectors
OK/FAIL LED, one bicolor:
•
Green—MIC is functioning normally.
•
Yellow—MIC has failed.
LINK LED, one green per port:
•
Off—No link.
•
On steadily—Link is up with no activity.
•
Blinking—Link is up and is active.
The ports are labeled:
•
2-port: [0/2]0, [0/2]1
•
4-port: [0/2]0, [0/2]1, [1/3]0, and [1/3]1
LEDs
Copyright © 2013, Juniper Networks, Inc.128
MX Series 3D Universal Edge Routers Line Card Guide