Datasheet

3. Tighten the screws on the connector.

NOTE:

For console devices, configure the serial port to the following values:

•

Baud rate—9600

•

Parity—N

•

Data bits—8

•

Stop bits—1

•

Flow control—none

Figure 30: Console and Auxiliary Serial Port Connector

Documentation

Routing Engine Interface Cable and Wire Specifications for the M7i Router on page 183.•

• M7i Power System Description on page 23

• M7i Router Power Requirements on page 167

• M7i Router Site Preparation Checklist on page 37

• Initially Configuring the M7i Router on page 67

• Connecting Power to an AC-Powered M7i Router on page 61

• Connecting Power to a DC-Powered Router on page 61

Inserting an SFP into the 1-Port Gigabit Ethernet FIC

Before inserting cables into the 1-port Gigabit Ethernet FIC, you must install a small

form-factor pluggable (SFP). Small form-factor pluggable (SFP) optical transceiver

modules provide support for SX, LX, and LH optics.

To install an SFP into the FIC, follow this procedure:

1. Verify that each SFP has a rubber safety cap covering the optical transceiver. If it does

not, cover the transceiver with a safety cap.

2. Carefully align the SFP with the slot in the FIC. The connector should face down.

3. Slide the SFP until the connector is seated in the FIC slot. If you are unable to fully

insert the SFP, make sure the connector is facing the proper direction.

Documentation

Installing an SFP into an M7i Router on page 100•

• Replacing an SFP on an M7i Router on page 98

Chapter 10: Connecting the M7i Router to External Devices