Datasheet

CHAPTER 7
Installing the M7i Router Mounting
Hardware
•
Installing the M7i Cable Management System on page 47
•
Moving the Mounting Brackets on page 48
Installing the M7i Cable Management System
The cable management system organizes and supports the PIC cables to prevent damage.
To install the cable management system (see Figure 26 on page 47):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
2. Use a number 2 Phillips screwdriver to loosen the screws that secure the mounting
brackets to the chassis, and remove the mounting brackets.
3. Locate the cable management racks and appropriate screws in the accessory box.
4. Slide the cable management rack into the slots at the front of the chassis.
5. Use a number 2 Phillips screwdriver to tighten the screws that secure the cable
management system to the chassis.
6. Reinstall the mounting brackets.
Figure 26: Installing the Cable Management System
Related
Documentation
M7i Cable Management System on page 27•
• M7i Chassis Description on page 6
47Copyright © 2012, Juniper Networks, Inc.